Activity Stream

Have a big B day on Ronbow !!!!!!!!!:016:

Happy Birthday Andy. Have a great day.

Happy Birthday, thanks for the info.

Dang nice motors that I know for sure. Runs out real nice he does a lot of bow fishing and trapping so its prefs for what he does. He's got it...

Back to my point..this is a reoccurring thing..and at 10k a pop that's a helluva lotta folks with negative feedback

Dang nice motors that I know for sure. Runs out real nice he does a lot of bow fishing and trapping so its prefs for what he does. He's got it...

Happy birthday Andy!

:sm45::sm45::drinking-48:

Have a great day eh!

Happy birthday, Andy. Stay safe and have a great time.

Happy Birthday Boatdr. Hope you have a great one.

Happy birthday Andy.

Have a great Birthday Boat Doc,and thanks for all you do helping us.

:sm45::sm45::sm45:

Happy B-day!!!!!! I wonder when he actually started celebrating?

Just a little tip, pull the cap off pump grease until its clean and when you put the rubber cap on push it in as much as you can and take a...

Thanks, I'll do that today.

It's under the rubber cap.

How do i get at the zerk? Is it in the axle under the boat, or do you mean you pry off those rubber coverings and it's under there? Thanks for...

Good to see some talk about the slt. I ran one all last season. They're not as fast as the surface drives, but they get on step a whole lot faster....

Be cool to get him to make the run this year. Since he is slower than you he can tow you back after you sink ur...... oh wait, nevermind!

Mine is an 06 and has made many miles,most recently to Cado,just keep it greased and check the temp on trips often. They have center drilled axels...

Dang!! Now you got the local kids running like maniacs. Methinks you to be a bad influence, Todd. :fireball: Tell Hunter he can ride with me. ...

barroll yes I do know that. I have posted before, and asked for help. tried to send him a p.m. but his in box was full. capncrunch thanks;...

BigD, When I had my Excel, I always had good success dealing with Dave Reynolds (national sales mgr.). He ALWAYS returned my calls and handled any...

Do the bearings need to be re packed and sealed every so often? If so approximately how many miles should it be done ?

You do realize the owner of excel is a member/admin here. Send him a pm. He seems to be helpful with the past excel issues I've heard about.

Yes they do. The zerk is actually in the axle so when you pump the grease in it has to travel through both bearings before it will exit. Makes the...